For overseas Machine specifications for small-sized electric injection molding machine MEt3 series (280-ton clamp capacity)

Information of machine specifications of MEt3 series with 280-ton clamp capacity

Machine specifications for small-sized electric injection molding machine MEt3 series (280 tons)
Model Units 280MEt III
Injection Injection system - In-line screw
Injection stroke mm 200 220 220 270
Screw diameter mm 50 55 60 55 60 68
Theoretical injection capacity cm3 393 522 622 522 763 980
Standard Injection unit - - -
Injection rate cm3/s - -
Max. injection speed mm/s - -
Max. injection pressure MPa - -
Max. injection holding pressure MPa - -
High-speed Injection unit - 20H 30H
Injection rate cm3/s 393 475 565 475 565 726
Max. injection speed mm/s 200 200
Max. injection pressure MPa 235.0 196.0 166.6 235.2 196.0 147.0
Max. injection holding pressure MPa 215.8 176.4 147.0 205.8 176.4 137.2
Superhigh speed Injection unit - - -
Injection rate cm3/s - -
Max. injection speed mm/s - -
Max. injection pressure MPa - -
Max. injection holding pressure MPa - -
Recovery rate (PS) kg/h 200 227 242 227 242 336
Screw revolution speed min-1 300 300
Nozzle pressing force kN 29.4 39.0
Clamping Clamping system - Double toggle
Clamping force kN 2744
Clamping stroke mm 600
Min. mold height mm 300
Max. mold height mm 650[750]
Tie bar clearance (H×V) mm 730x730
Die plate size (H×V) mm 940x940
Ejector force kN 60
Ejector stroke mm 150
Other Heater capacity kW 13.50 16.70 19.50 16.70 19.50 24.80
Mold height motor output kW 0.4
Nozzle touch motor output kW 0.4
Machine dimension <L> mm 6732 8834 8978 7234
Machine dimensions <W×H> mm 1581x2222
Power source - Three-phase AC200V/200, 230V±10% 50Hz/60Hz
Main breaker capacity A 300
Total electric capacity KVA 52 63
Cable size
200V Class[400V Class *1]		 mm2 100[38]
Machine weight t 17.0 17.5
NOTES
  1. The figures are subject to change without any legal obligation on the part of the manufacture.
  2. The specifications are expressed in SI.
    (1MPa=10.2kgf/cm2 1kN=0.102tonf)
  3. The maximum injecting pressure and the maximum holding pressure are attainable maximum set values. There values may be limited by molding conditions and cycle time.
  4. The injection rate and the maximum injecting speed are calculated values.
    These values may be limited by set injecting pressures.
  5. When a screw with wide diameter is used, some resins may not be accepted.
  6. When the machine is attached with an option, the capacity of the breaker.may be changed.
  7. The values in brackets are applied to machines with options.
    *1.A transformer(option) is necessary on the machine side.

Copyright(C) MITSUBISHI HEAVY INDUSTRIES PLASTIC TECHNOLOGY CO.,LTD. All Right Reserved.