Mold mounting dimension diagram for large-sized hydraulic injection molding machine MMV series (1,300-ton clamp capacity)

Introduction to machine specifications of MMV series with 1,300-ton clamp capacity

Machine specifications for large-sized hydraulic injection molding machine 1300MMV

Model Units 1300MMV
160 240 340
Injection Screw diameter mm 105 120 135
Theoretical injection capacity cm3 4,540 6,780 9,660
Injection mass Polystyrene (PS) g 4,180 6,240 8,890
Polyethylene (PE) 3,360 5,020 7,150
Maximum injection pressure MPa
(kgf/cm2)		 160.8
(1,640)
Injection rate cm3/sec 1,075
(865)		 1,200
(1,000)		 1,260
(1,050)
Plasticizing capacity PS kg/h 615
(510)		 545
(455)		 730
(610)
PP


Screw RPM rpm 159
(133)		 114
(95)
Clamping Mold clamping force kN (tonf) 12,749
(1,300)
Mold opening force 785
(80)
Mold closing speed m/min 49(49) 49(46) 49(46)
Mold opening speed 46(46) 46(43) 46(43)
Platen size (H x V) mm 1,920×1,900
Tie bar space (H × V) 1,320×1,280
Clamp capacity stroke 1,800
Daylight 2,500
Mold thickness 700~1,200
Ejector Ejector force kN
(tonf)		 294
(30)
Stroke mm 250
General Electric motor for pump kW 132 147 165
Heater capacity 47.6 46.0 59.4
Oil resovoir capacity L 2,000
Machine dimensions L m 9.9 10.0 10.8
W 3.2
H 2.9
Machine mass tons 63 65 68
Wide type
Model Units 1300MMVW
240 340 470
Clamping Platen size (H x V) mm 2,000×2,000
Tie bar space (H × V) 1,450×1,400
General Machine dimensions L m 10.3 10.9 11.4
W 3.4
H 3.0
Machine mass tons 68 71 75
  • 1. The numeric values in this table are subject to improvements or changes without notice.
  • 2. When the numeric values in this table are 220 V, 60 Hz, there is a chance that 200 V, 50 Hz might appears inside the ( ).
  • 3. Injection mass, injection ratio, and plasticizing capacity differ depending on the resin used and molding conditions.


Copyright(C) MITSUBISHI HEAVY INDUSTRIES PLASTIC TECHNOLOGY CO.,LTD. All Right Reserved.