Machine specifications for large-sized hydraulic injection molding machine MMV series (1,600-ton mold clamping force)

Introduction to machine specifications of MMV series with 1600-ton mold clamping force

Machine specifications for large-sized hydraulic injection molding machine 1600MMV

Model Units 1600MMV
240 340 470
Injection Screw diameter mm 120 135 150
Theoretical injection capacity cm3 6,780 9,660 13,200
Injection mass Polystyrene (PS) g 6,240 8,890 12,100
Polyethylene (PE) 5,020 7,150 9,770
Maximum injection pressure MPa
(kgf/cm2)		 160.8
(1,640)
Injection rate cm3/sec 1,200
(1,000)		 1,260
(1,050)		 1,275
(1,060)
Plasticizing capacity PS kg/h 545
(455)		 730
(610)		 810
(675)
PP


Screw RPM rpm 114
(95)		 118
(98)
Clamping Mold clamping force kN (tonf) 15,691
(1,600)
Mold opening force 971
(99)
Mold closing speed m/min 45(37) 45(42) 44(41)
Mold opening speed 45(37) 45(42) 44(41)
Platen size (H x V) mm 2,200×1,950
Tie bar space (H x V) 1,520×1,280
Clamp capacity stroke 2,400
Daylight 3,200
Mold thickness 800~1,500
Ejector Ejector force kN
(tonf)		 294
(30)
Stroke mm 250
General Electric motor for pump kW 147 165
Heater capacity 46.0 59.4 72.3
Oil resovoir capacity L 2,000
Machine dimensions L m 11.0 11.6 12.1
W 3.6
H 3.0
Machine mass tons 81 84 88
Wide type
Model Units 1600MMVW
240 340 470
Clamping Platen size (H x V) mm 2,450×2,250
Tie bar space (H × V) 1,800×1,600
General Machine dimensions L m 12.0 12.1 12.7
W 3.8
H 3.4
Machine mass tons 97 100 103
  • 1. The numeric values in this table are subject to improvements or changes without notice.
  • 2. When the numeric values in this table are 220 V, 60 Hz, there is a chance that 200 V, 50 Hz might appears inside the ( ).
  • 3. Injection mass, injection ratio, and plasticizing capacity differ depending on the resin used and molding conditions.


Copyright(C) MITSUBISHI HEAVY INDUSTRIES PLASTIC TECHNOLOGY CO.,LTD. All Right Reserved.