Special screw for PP containing long glass fiber

Long glass fiber Open fiber Chip Low shear Metal substitution Module Exchange path check ring Low shear screw design Air shot

Introduction to Technology
Special screw for PP containing long glass fiber
Special screw for PP containing long glass fiber
Plasticization technology for modules of large-scale molded parts (automobile parts)
High strength, high heat resistance, and lighter weight (substitution of metal material)

Screw design
  • Achieves customer's plasticization requested quality through the use of an optimum design that controls shear during melting.
Wide flow path check ring Low shear screw design
Features
  1. Small amount of fiber chipping.
    • High strength, high heat resistance, and lighter weight (substitution of metal material)
Material fiber length Remaining fiber length inside air shot
Screw diameter: φ120 Screw diameter: φ135
9 mm 5.11 mm -
15 mm - 6.26 mm
Fiber distribution state inside air shot
Fiber distribution state inside air shot
Click an image to enlarge it.
  1. Good fiber breakdown and dispersal
    • Surface of molded part is clean (glass fiber does not appear on surface)
    • Uniform molded part strength
  1. High plasticization capacity
    • Enhanced productivity

To inquire about a molding test, contact the nearest sales office or service center



Copyright(C) MITSUBISHI HEAVY INDUSTRIES PLASTIC TECHNOLOGY CO.,LTD. All Right Reserved.